Skip to content
Back to Heat Pumps
Outdoor heat pump unit beside a Canadian home
Heat Pumps

Haier Arctic Series Heat Pump Review

One of few ductless brands with a published US government lab test, which found aggressive defrost until software changed. Canadian evidence is thin.

Arshia Jahangiri
5 min

Table of contents

Haier's Arctic ductless line is backed by a rare public test: a US Department of Energy and NREL study of a one-ton GE-Haier unit in a climate chamber and in Fairbanks, Alaska. It showed good capacity retention in the cold, but also defrost cycles that wasted run time until the software was changed. Canadian owner evidence is almost nonexistent, and the extended warranty needs registration within 60 days.

What the lab study found

The study summary was prepared for the 2024 DOE Building Technologies Office peer review by the National Renewable Energy Laboratory with Haier and GE Appliances as partners. It tested a 1-ton GE-Haier ductless mini-split with an advertised operating range to −31 °F (about −35 °C). The slides do not name the model, so we cannot confirm it matches an Arctic unit sold in Canada. Preliminary chamber results listed:

  • generally good COPs and capacity retention, with COP above 1 down to −35 °F;
  • about 12,000 Btu/h of capacity at −12 °F (about −24 °C);
  • in the field test with the original "aggressive" software, defrosts about every 55 minutes, each lasting about 8 minutes, with about 60% of time spent in defrost or recovering from it;
  • after software changes, a 65% to 85% cut in defrost runtime and about a 50% rise in efficiency below 25 °F;
  • defrosts that became more frequent at lower temperatures even in dry chamber conditions, with a 260 W drain-pan heater running about half the time at 14 °F;
  • an indoor fan that sometimes shut off while the compressor kept running at low loads, a risk when a backup heater runs at the same time.

The summary says Haier and GE implemented software changes to their current product, but we could not confirm which production units, or Canadian shipments, carry the update. It is one unit, preliminary data and an Alaskan site, not a Canadian home.

The Arctic lineup, as reported

Furnaceprices.ca, a lead-generation site (page updated September 1, 2026), says Haier's heat pumps are all ductless and variable speed, with the Arctic Series the cold-climate line. It lists:

  • Arctic Single-Zone at 27 SEER2 and 11 HSPF2, about $5,000 to $7,500 installed, which it says is not ENERGY STAR certified;
  • Arctic Multi-Zone at 19.5 SEER2 and 10.2 HSPF2, ENERGY STAR certified, about $9,000 to $15,000;
  • FlexFit, Tempo and Advanced Plus single-zone and FlexFit multi-zone families at lower prices.

Haier's own US pages blocked our access, so we are not quoting its 100% at 5 °F, −22 °F or −31 °F claims or its SEER and HSPF headline figures. Confirm which Arctic generation and rating the Canadian model number carries. Furnaceprices.ca says Haier's North American HVAC is sold and supported through GE Appliances, which Haier acquired in 2016, and describes that as a distribution advantage rather than shared engineering.

Owner and installer evidence

  • Furnaceprices.ca says Haier's heat pump owner reviews on its platform are not yet established, so there is no Canadian owner base to quote.
  • HeatingHelp (December 2024): a US owner of a multi-zone Haier found one indoor unit not heating well with outdoor temperatures of 24 to 42 °F. Replies suggested checking charge or line-set length, and the thread reads as an installation and commissioning question. It is one anecdote.
  • Review sites (Pick Comfort and PickHVAC) blocked our access. We found no Canadian reviews on HomeStars or forums and no failure-rate data.

Warranty: registration within 60 days

Furnaceprices.ca says every Haier heat pump carries the same terms: 5 years on parts and 5 on the compressor as standard, extending to 10 and 10 when the unit is registered within 60 days of installation. It says there is no labour allowance or unit-replacement provision, and that Quebec residents get the extended coverage without registering. We could not open Haier's own warranty document, which the earlier research recorded with different base terms and extra conditions (licensed installer only, no online retailers, not transferable), so those are unconfirmed. Ask for the document that ships with your exact model and sale date, and who files the registration.

What it costs

Solenery does not set prices, and Haier's Canadian pricing is not published. Third-party ranges, installed and before rebates:

Source Scope Range
Furnaceprices.ca brand table (Oct 9, 2026) Ductless Haier, single to multi-zone $5,000 to $9,500
Furnaceprices.ca review page (Sept 1, 2026) Single-zone families $4,000 to $7,500
Furnaceprices.ca review page Multi-zone $8,500 to $15,000

Both come from the same lead-generation site, so they overlap rather than confirm each other, and none is a Haier quote. Line-set length, electrical work and head count move prices. Get three written quotes for the same scope.

Rebates and the cost gap

Furnaceprices.ca says the Arctic Single-Zone is not ENERGY STAR certified while the Multi-Zone is, so rebate eligibility can differ between two Arctic models. Check the exact outdoor and indoor pairing against the federal product-list guidance before you sign.

Check your heat-pump rebate eligibility

Explore heat-pump rebates you may qualify for through a property assessment.

Explore heat-pump rebates

Who it suits

Haier suits homeowners who want an efficient single- or multi-zone ductless system from a large manufacturer at a lower price than the premium Japanese brands, with an installer experienced in cold-climate commissioning. It is a harder sell if you want proof from many Canadian owners. Compare Mitsubishi, Fujitsu or LG for deeper Canadian owner feedback and dealer networks if your winters are very cold.

Questions to ask your installer

  1. Which Arctic outdoor and indoor models are quoted, and are they listed together as a matched pairing?
  2. Does the unit carry the updated defrost and efficiency software, and can you read me the controller version?
  3. Will you register it within 60 days and give me proof?
  4. What does the capacity table say at my design temperature, and do you recommend backup heat?
  5. Who handles warranty parts and service in my province, and do you offer a labour warranty?

Sources

Share this article