
York HH8 and Affinity Heat Pump Review
A licensed brand now under Bosch that shares platforms with Coleman and Luxaire. What a Quebec...

A hydronic specialist now part of Carrier. Where the 100-AW fits radiant homes, what its ductless sibling shares with other labels, and the evidence gaps.
Viessmann Canada sells two different heat pumps: the Vitocal 100-AW air-to-water system for radiant floors, baseboards or fan coils, and the Vitocal 100-S ductless system launched in February 2025. The 100-AW suits hydronic homes if the emitters work at low water temperatures. We found no Canadian owner reviews of substance, and Viessmann says it is now part of Carrier.
The Vitocal 100-AW is an all-in-one air-to-water kit: an outdoor unit, an indoor unit and a 20 US gallon steel buffer tank, in three sizes of 20.5, 34 and 58 MBH (6, 10 and 17 kW) of heating. Viessmann Canada's page lists R32 refrigerant, an integrated controller, a dual-fuel switch for pairing with an existing boiler or furnace, and outdoor sound of 52 to 56 dB at 3 feet.
The Vitocal 100-S is a single-zone ductless air-to-air system, announced by Viessmann Canada in February 2025 (ACHR News), with multi-zone Vitocal 200-S units to match. Its Canadian specification page lists R410A refrigerant and outdoor model numbers in a "DLCSRBH" series. Heat Pump Review lists the same "DLCSRBH18AAK" outdoor model on a Kenmore unit that it describes as a Carrier sub-brand, so these labels appear to share hardware, which is common in the Carrier family. We found no Viessmann or Carrier statement confirming that the units are identical, so treat the overlap as likely but unconfirmed. Our Kenmore review covers the same platform.
For the 100-AW, Viessmann Canada lists a minimum outdoor air temperature of −13 °F (−25 °C), a maximum of 109 °F (43 °C) and COP of 4.93, 4.91 and 4.24 for the three sizes, at test conditions the page does not state. A rated COP is not what you get in January.
For the 100-S, the page states operation from −22 °F to 86 °F (−30 °C to 30 °C), "100% heating capacity at −4 °F (−20 °C)" and efficiency up to 28.1 SEER2 and 13.6 HSPF2, with a built-in base pan heater. The US-hosted version of the same listing cited 100% at −15 °C; the Canadian page says −20 °C, so check which spec sheet applies to your model.
On HeatingHelp, a Halifax homeowner planning a 100-AW read the manual and reported about 25,000 Btuh at −25 °C with 41 °C water, which matched his design load. That is a forum member reading a manufacturer chart, not a measured result. A Caleffi trainer in the same thread said he runs the same unit in his shop at 115 °F or lower and noted COP drops near 14 °F. Hydronic performance depends on emitter water temperature, so a heat-loss calculation for each room matters more than nameplate output.
Canadian owner evidence is close to nil. The one first-hand 100-AW account we read is the Caleffi trainer's, who works for a competing hydronic vendor and ran a unit in his shop, not in a home. Two short testimonials on a retailer page, which we could not re-read, are not independent. Trustpilot's European reviews concern different models and markets, so we do not use them. We found no HomeStars, RedFlagDeals, GreenBuildingAdvisor or BBB reports on these Canadian products.
Viessmann Canada's 100-AW page lists a limited 5-year compressor warranty, 3 years on individual components of the indoor and outdoor unit, and 1 year on fittings. The 100-S page lists a limited 10-year warranty on the individual components of the outdoor and indoor units for residential applications. The warranty page lists a 100-AW sheet (PDF), but we did not read it, and neither product page states a registration requirement, labour terms or installer conditions. Get the certificate for your model in writing and ask who pays labour.
Solenery does not set prices, and Viessmann publishes no installed price. The only price source we could read is a Get a Better Quote guide for Ontario (published April 21, 2026), a commercial site, which puts a hybrid air-to-water package at $15,000 to $30,000 for the heat pump plus $2,000 to $4,000 for a buffer tank and $1,000 to $3,000 for controls and commissioning, or $18,000 to $37,000 before rebates. That is a general air-to-water range, not Viessmann-specific, and it is far above ductless pricing. We found no Canadian installed range for the 100-S. Ask for itemized quotes covering emitters, buffer tank, electrical work and controls.
Use the federal product-list guidance to verify the matched equipment. Eligibility for an air-to-water system depends on the exact listing, and the ductless units follow the outdoor-and-indoor combination rule, so ask for the model numbers on the bid.
Explore heat-pump rebates you may qualify for through a property assessment.
Explore heat-pump rebatesThe 100-AW suits a home with low-temperature radiant floors or a boiler it can pair with in dual-fuel mode, and an installer who sizes emitters and water temperature. Older baseboards sized for hot boiler water may need added emitters or the built-in electric element on the coldest days. For ordinary ducted or ductless homes, compare brands with a longer Canadian record, such as Mitsubishi.

A licensed brand now under Bosch that shares platforms with Coleman and Luxaire. What a Quebec...

A Whisperline heat pump is part of a building loop, so replacing one is a building decision....

A ground-source brand where the buried loop matters as much as the unit. What WaterFurnace...